yudo and extenz 208

Summertime is finally here, and so are challenges of shooting outdoors in the harsh summer sun. Although the winter months provide us with plenty of diffused cloud cover to properly expose out actors, the harsh, direct summer sun can be problematic when the light and shadows fall outside the contrast ratio of the camera.

In working with the sun, treat it in the same way you’d treat the key or rim light. The only difference is that you need to move the subject and camera to position the sun in the ideal location. Many times, locations are selected because of their east-west orientation, enabling the Director of Photography and 1st assistant director to schedule specific shots based on the sun’s position.

Working with sunlight begins by choosing the position of the subject relative to the position of the sun. There are two ways to approach shooting using the sun as the primary light source:

  • Use the sun as the key light – Position the actor so the sun is illuminating the far side of the actor’s face, opposite the actor’s eye line. This is much easier to do before 11:00 AM and after 4:00 PM, when the sun hangs lower in the sky. Avoid shooting near noon, because the sun tends to cast shadows on the actor’s brow, creating deep, cavernous shadows over the actor’s eyes. Use a bounce board to fill in some of the shadows, especially if the sun is too direct.
  • Use the sun as a rim light – Position the actor so the sun is positioned behind her, then use a bounce board or reflector to bounce the sunlight as the key light. I would recommend using a silver reflector available at most camera stores.

Here are some tips for getting a great shot in direct sunlight:

  • How much workable daylight is there – The 1st assistant director will look at the script and estimate the amount of time needed to shoot a particular scene, or to shoot all the scenes at one given location. He will then determine whether there is enough workable sunlight to be able to complete your shot list.
  • How much time will it take to chase the sun – Chasing the sun is a term that refers to the constant adjustments to the grip equipment needed to compensate for the sun’s movement. Reflectors, diffusion and overheads all need to be moved, which takes time and manpower. The schedule will determine whether the day will permit extensive rigging changes.
  • Are there geological or architectural features that will cut into the sunlight – Sunlight calculators provide sunset and sunrise times based on the moment the sun crests the horizon to the time the sun dips below the horizon. The actual time may vary if the sun travels behind a building or a mountain range. Often, location scouts will perform a light survey, during which they sit at a location all day and note the exact times of direct sunlight. These times are important to know when determining the daily shooting schedule.
  • Plan for lighting changes – A good director of photography will be able to plan not only camera angles to allow a consistent look of the lighting throughout the day, but determine a way to shape the changing sunlight so the look of the final footage is consistent in the scene. Often this involves flying a large 20’x20’ silk over the set so direct sunlight is diffused, then focusing the direction of the sunlight with shiny boards.
  • Be prepared for weather changes – Even the best-laid plans are subject to a cloudy day, where overcast conditions make it much more difficult to reflect light. Instead of bouncing light to increase the illumination levels on one side of your subject, DPs will use solids to reduce the light, creating negative fill on the opposite side of the actor. Whether you add light to one side or subtract light from the other, the goal is to create a consistent contrast ratio from shot to shot.
  • Make sure you have room to rig – Reflectors and overheads can take up a lot of space, so when scouting a location, make sure there is ample room to rig the necessary fixtures. Sometimes, it becomes necessary to place reflectors on nearby building rooftops, or rig overhead silks to a neighboring structure. Be sure to discuss these requirements with the location manager so she can secure all necessary permissions and permits from surrounding property owners.

Remember, the sun is a giant light source that can be diffused, bounced, reflected and blocked. With a little creativity, you can help shape sunlight to create the best possible image for your production.

Share this post

Join FilmSkills Today

Choose from 12 courses, packed with on-set tutorials taught by Academy Award and Emmy winning filmmakers, plus illustrated tutorials, downloadable resources, and a personalized certificate of completion.

Or get it all and save over 70%

Access everything, and all future content.... for life

Why pay $3,388 to buy all FilmSkills courses individually when you can get it all for only

one payment of $949